Installation Instructions

** You can proceed through this page for installation instructions.

❤ Backlit House numbers and illuminated address plaque share the following connection diagram. For plaques, you simply default the numbers in the connection diagram to the plaques. 

Please refer to the installation wiring diagrams below for demonstration.

Illustrations:

  1. Stick paper template on wall and drill holes base on the template.The diameter of thread rod hole is 4mm.The diameter of the wire hole is 8mm.
  2. Screw thread rods into the number, and silicone glue the outside thread rods.Or glue the backside of the numbers.
  3. Insert the thread rods onto the holes,pass the electricity wire through the hole.

Installation instructions:

Correspond to the formula below according to the accessories you choose. Then view the corresponding wiring diagram to install.

Wiring diagram 1 :

AC Transformer + Numbers

 

AC Transformer + Timer + Numbers

 

AC Transformer + Dimmer + Numbers

 

AC Transformer + Timer + Dimmer + Numbers

Wiring diagram 2 :

Note of Dusk to Dawn Switch(Light Sensor)

  1. Do NOT install the Light Sensor in the very dark place(daytime).
  2. Light Sensor should be far away from the lighting house number and other lamp light source.
  3. Light Sensor Switch turn on when lighting lower than 30Lux after 10s. Turn off when lighting higher than 150Lux after 10s.

AC Dusk to Dawn Switch + AC Transformer + Numbers

 

AC Dusk to Dawn Switch + AC Transformer + Dimmer + Numbers

 

AC Transformer + DC Dusk to Dawn Switch + Numbers

 

AC Transformer + DC Dusk to Dawn Switch + Dimmer + Numbers

Wiring diagram 3 :

Low Voltage AC to DC Transformer + Numbers

 

Low Voltage AC to DC Transformer + DC Dusk to Dawn Switch + Numbers

 

Low Voltage AC to DC Transformer + Dimmer + Numbers

 

Low Voltage AC to DC Transformer + DC Dusk to Dawn Switch + Dimmer + Numbers

Wiring diagram 4 :

AC Transformer + RGBWW

 

AC Dusk to Dawn Switch + AC Transformer + RGBWW

 

AC Transformer + DC Dusk to Dawn Switch + RGBWW

Wiring diagram 5 :

1 Set Solar Power Bank(for Small Size) + Numbers

 

2 Sets Solar Power Bank (for Large Size) + Numbers

CAUTION: 

Installation instructions and wiring diagrams are for reference only. Wiring and installation should be done be a certified electrician after verifying the right connection diagrams.

The backlit house numbers are 12V DC which means they cannot be connected directly to any AC power source. You will need to connect them to the power transformer (100-240V AC to 12V DC) first (make sure to connect them to the correct side of the power transformer) and then connect the power transformer to the 100-240V AC power source.